I am trying to setup "Operational Control" of some of our reporting, so that Operations can manually recover reporting in the event of delays or failures in processing.
I have a user "operator" that is part of the Consumer Group and I wish this user to manually run jobs containing bursted reports (jobs containing non-bursted reports complete without issue).
However, upon execution, they are getting the following message "RSV-SRV-0029 The user does not have the assigned capability to use bursting. CAF-WRN-2082 An error has occurred..."
I have set the Bursting Property for Report Studio for both the individual user and then subsequently Group/role to Execute and Traverse, and the user has Read/Write/Execute/Traverse permissions to the Job and the individual Reports.
Any thoughts would be greatly appreciated.
Thanks in advance,
Adam.
Hello adam_mc,
Under IBM Cognos Administration > Security > Capabilities, click on Report Studio. You will see an entry called "Bursting". Make sure that you have access to this capability by looking at the permissions specified for this capability.
-Cognos810
Thanks 810, but that was the part I'd already done.
What I'd missed was adding Bursting Capabilities for the User/Role to the Package itself:
- Open the property sheet for the package
- Click on the Capabilities tab
- Verify that the user belongs to a group listed there where bursting is enabled
- Add Bursting capability under Report Studio