Print Page - Transformer freezing when create a cube

Title: Transformer freezing when create a cube
Post by: orbair on 07 Jul 2014 11:11:57 AM

Hi all,

Did someone faced that problem, when creates a cube, it started, but after 1-2 sec nothing happens, and when you click on it said not responding? I have to close the program, and I am unable to create cubes.

Thanks

Title: Re: Transformer freezing when create a cube
Post by: Karti on 07 Jul 2014 12:25:09 PM

Hello Morfeusz,

I encounter this issue as well, but we leave it running for a little while and it will keep going with the cube building. This only occurs with manual cube builds, as we see some small cubes build in a short period of time through script.

Have you tried leaving it as 'Not Responding' for lets say.....10 or so minutes to see if it continues? The time it occurs on my end is never the same, but it always picks back up and finishes.

If anyone has a permanent solution to this, it would be much appreciated.

Title: Re: Transformer freezing when create a cube
Post by: Grim on 07 Jul 2014 02:06:33 PM

Running as Administrator?
Enough free disk space?

Title: Re: Transformer freezing when create a cube
Post by: orbair on 08 Jul 2014 10:14:36 AM

Thanks Karti, you were right.

COGNOiSe.com - The IBM Cognos Community

IBM Cognos 10 Platform => Cognos 10 BI => Transformer => Topic started by: orbair on 07 Jul 2014 11:11:57 AM