blank page on the report

[Little Princess]

Hello experts,

I have a report where I have to have output options: policy, division and subdivision, all my data separated in blocks and repeated in each block, the selection of each bloc is controlled by render variable. I also have two queries that have Master-Detail relationship configured.

I have filters setup for both queries and it works well, but it brings me blank page at the end of the report. Why is it doing and how can I stop it?

Any help greatly appreciated.

Cheers
LP

[jayani]

Why don't you try setting up the variable for the list instead of the block?

[Little Princess]

Hi jayani,

I tried to do that and it still gives me a blank page.
At the bottom of my report I have a table that carries all the parameters, this table normally would show up at the end of each entity: policy, division, subdivision. The blank page would have this table and no other data.
Now when I moved the variable to the list this table shows up firs with the blank page and then I get report data.
Cheers
LP

[jayani]

Hi Princess,

Is the table placed inside a block or something?
Please do check whether any height and width or padding has been set.
B'coz thatz the one which will cause wide space to appear.

[Little Princess]

Hi jayani,

This table sitting at the bottom of the report, it is not in a block.
It’s company standard, so I can’t get rid of the table.
I changed all the spacing, just like you recommended, it didn't make any difference.

I appreciate your help.
LP