Where can i find "Use Same Range for All Instances" in Cognos 10?

[pimogo]

In Cognos 8, this was located in the properties under y1 axis, but can't find it in Cognos 10.

I notice that my bursted charts aren't scaling correctly and therefore some of the charts contain their graphs towards the very bottom of the chart. In the past, i have selected "NO" to "Use Same Range for All Instances", but can't find it. If anyone can help, much appreciated.

THanks!

[CognosPaul]

Click on the primary axis line. Not the arrow pointing up from 0 to n, click on the line just to the right of that.

Once your on the primary axis click on the Axis Range. If the chart has a master/detail set up you should see the "Same range" checkbox.

[pimogo]

perfect! many thanks!

[ersin.gulbahar]

thanks

[ersin.gulbahar]

In Cognos 8, this was located in the properties under y1 axis, but can't find it in Cognos 10.

I notice that my bursted charts aren't scaling correctly and therefore some of the charts contain their graphs towards the very bottom of the chart. In the past, i have selected "NO" to "Use Same Range for All Instances", but can't find it. If anyone can help, much appreciated.

THanks!

[binhnta]

Thanks Paul a lot!

Just a little bit different from your guide. In my version 10.2.1, I did not find the Same range property, instead, after choosing the Primary Axis, I found Axis Range property and clicked on the three dots next to it, then uncheck the box "Same range for all instances of chart". It works as well.

Best Regards,