Maps - Report Studio

[mbomabe]

Hi, Anyone knows how to setup a Master-Detail relationship between a map and an another object, as a List. The master would be the map and the detail will be the detail. It works when I use a Active Report, using a deck, but I wanna use in the standard report.

  Best regards,

      marcelo

[Raghuvir]

Hi,

if u want to bet redirected to a detailed report, u should use drill through definitions.

just try it once and check if u have the desired output.

[MFGF]

Hi,

You can embed a map within a list, but not a list within a map. This means the list will always be the master and the map will be the detail.

Drilling through (as suggested) seems to be the solution you need here.

Regards,

MF.

[mbomabe]

So, the objective of the report is when the user click in a state on the map, the list is filtered by this state. In active reports works, but in standard report ( no active report ) the master-detail option in list is not available. I know that in Active Reports works cause the map and the list are inside a Deck, but there isn't a Deck object in standard reports.

[MFGF]

Hi,

You can't have a map as a master in a master/detail relationship. In your Active Report you are filtering a list based on the selection made from the map, but the map isn't a master query. To achieve similar functionality in a non-Active Report you will need to set up a drill-through definition from the map to pass the selected region value. Your drill-through target will be the same report, and your list will be filtered based on a region parameter. You can either hide the list using conditional rendering when the report is first run, or you can define a default value for the parameter which corresponds to all regions.

There are a few posts on here that discuss drilling through to the same report, if memory serves. Do a search and take a look at the recommendations. Come back to us if you get stuck.

Good luck!

MF.