Transformer freezing when create a cube

[orbair]

Hi all,

Did someone faced that problem, when creates a cube, it started, but after 1-2 sec nothing happens, and when you click on it said not responding? I have to close the program, and I am unable to create cubes.

Thanks

[Karti]

Hello Morfeusz,

I encounter this issue as well, but we leave it running for a little while and it will keep going with the cube building. This only occurs with manual cube builds, as we see some small cubes build in a short period of time through script.

Have you tried leaving it as 'Not Responding' for lets say.....10 or so minutes to see if it continues? The time it occurs on my end is never the same, but it always picks back up and finishes.

If anyone has a permanent solution to this, it would be much appreciated.

[Grim]

Running as Administrator?
Enough free disk space?

[orbair]

Thanks Karti, you were right.